DCS2500 Stationary Air Filtration

dcs2In all Extrusion and Injection molding cleaning operations there is a quantity of smoke and fumes that may need to be removed depending on the customers needs and expectations as well as local regulations. With a Fluidized Temperature Bath the waste is in the form of smoke, particulate and fumes which occurs due to Pyrolysis of the plastic. This waste can be easily removed from the exhaust stream by the stationary model DCS2500 HEPA Air Filtration system as shown in the product brochures below. In manufacturing plants where an exhaust system is already in place to capture smoke and fumes from Extruders, other operations and the tool room, a filtration system may not be required. If one is necessary our system will remove smoke, particulate and fumes while reducing odor from the exhaust stream allowing the filtered air to be vented directly outside or into the plant exhaust stack.

Model DCS2500
Inlet Plenum size 8" OD
System air flow rate, SCFM 1000
Applications moderate to heavy duty cleaning and smoke/fumes/odor removal
Filter details 4 stage with easy side access
Oil mist impinger collects polymer oil mist from exhaust stream, byproduct of Pyrolysis
Filter 1st stage 4" disposable Merv rated prefilter
Filter 2nd stage Primary barrier HEPA 99.99% removal down to 0.3 micron in a lever lock sealed housing
Filter 3rd and 4th stage Two canisters each containing 45 pounds of refillable activated carbon.
Configuration Vertical or horizontal stationary free standing
Additional Requires an external blower
Dimensions 27" x 27" x 108"H
Weight 800 lbs
Catalog # ATS1036
Plumbing diagram for connection to Fluidized Temperature Bath. Diagram 3 System Layout
Interconnecting plumbing, fitting, damper and bleed in valve can be purchased from www.ductincorporated.com

Download the brochure for full system details. DCS2500 (PDF Download 269Kb)